At 07:22 PM 7/13/2010, you wrote:
>I wondered if someone local (US) could get UNF tap and dies
>
>http://products.tapcousa.com
>
>This outfit sells a single 1/2"-20 UNF set for around 29.00US plus shipping.
>The other choice is 1/2"-13 which sounds like course thread.
>
>Someone else is welcome check their site, enter the information and
>see if they
>come up with similar results, or maybe another supplier.
If you are going to chase and re-thread the frame tube nuts, you will
need a tap with an extended shank. The standard shank length will
not get you far enough into the tube to do this job
correctly. McMaster-Carr P/N
<http://www.mcmaster.com/itm/find.ASP?tab=find&context=psrchDtlLink&fasttrack=False&searchstring=2582A21>2582A21
will do the job nicely. I use this on every frame I repair when I
attach my reinforcing plates.
Tom Hall
ModTiger Engineering LLC
www.tigerengineering.net
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|