Measuring the 'off car' circumferance doesn't give you a very accurate
'tire revs. Per mile' as it's compressed on the bottom making the
rolling diameter slightly smaller. When I sent the numbers to get a
custom speedo gear for my Sprite/B210 5 sp. Conversion they asked that
I mark the tire and ground with a chalk mark and then roll the car one
tire revolution and make another mark on the ground and take a
measurement between them to show 'rolling' circumferance...
Jim
B382000446
Sent from my iPhone
On 2010-07-04, at 4:31 PM, "Thomas Witt" <atwittsend@verizon.net> wrote:
> Back in 2003 Ron Fraiser sent this to the list:
>
>>>> Good Question about the original tires. I don't know the real
>>>> answer; I can only reverse engineer the size of the tire from the
>>>> printed facts in the
> manual and on hand.
>
> Original Tire = 5.90 x 13 - not much help here.
>
> 1-From the Tiger Manual - 23.92mph @ 1000 rpm Calculate tire size
> using 2.88 gears Tire circumference = 72.75" - Diam. = 23.15"
>
> 2-Let's calculate again using the speedometer gear ratios. Speedo
> cal# = 980 rev/mi, speedo cable gear = 15 teeth,
> trans drive gear # B7C-17285-A = 6 teeth, 2.88 gears
> This gives you 24.49mph @ 1000rpm
>
> Tire circumference = 74.48" - Diam = 23.71"<<<
>
>
> A number of years ago (6 years to be more accurate) Jim Boynton sent
> me the circumference of his original, barely used spare tire. It was
> 74.875".
>
> So, for those that want to be "factory accurate" take your pick.
> 72.25", 74.48", or 74.875 as each has its merits. In closing his
> post Ron wrote, "I hope this helps and doesn't confuse people too
> much." I would agree.
>
> Tom (Witt)
> _______________________________________________
> Tigers@autox.team.net
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/tigers/jim@island.net
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|