Look in you local hardware store (ace, etc. They usually have
a nice selection of nylon bushings. You should be able to
find something that'll work.
--- On Wed, 12/9/09, Jeff Howarth <jeff@v8tiger.demon.co.uk> wrote:
From: Jeff Howarth <jeff@v8tiger.demon.co.uk>
Subject: Re: [Tigers] Tigers Digest, Vol 3, Issue 479
To: "Smit, Theo" <Theo.Smit@dynastream.com>
Cc: Rollright@aol.com, tigers@autox.team.net
Date: Wednesday, December 9, 2009, 11:45 PM
I wonder if a small a nylon grip tie would work ?
In message
<60FEBF2884916145962401D18221D157019056CA@dsimail.ad.garmin.com>, "Smit,
Theo" <Theo.Smit@dynastream.com> writes
>The parts guide
>http://www.tigersunited.com/resources/factory_parts_list/Tiger/Tiger%20I
>I%20Supplement%20Section%20RF.pdf
>Doesn't show a lot of detail. Is it just a split nylon washer? It
>should be fairly straightforward to machine one out of nylon or another
>engineering plastic such as Delrin.
>
>Theo
>
>> -----Original Message-----
>> From: tigers-bounces@autox.team.net
>> [mailto:tigers-bounces@autox.team.net] On Behalf Of Rollright@aol.com
>> Sent: December 8, 2009 3:38 PM
>> To: tigers@autox.team.net
>> Subject: Re: [Tigers] Tigers Digest, Vol 3, Issue 479
>>
>> Tod,
>>
>> Isn't that the split oddly shaped nylon piece? I always
>> wondered as to its function. I wonder where one can get one.
>>
>> Anybody know?
>>
>>
>> Jim Armstrong
>> Mk 1A 382002083
>> LRXFE
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>You are subscribed as jeff@v8tiger.demon.co.uk
>
>Tigers@autox.team.net
>http://autox.team.net/mailman/listinfo/tigers
>
>http://www.team.net/archive
>
--
Jeff Howarth
You are subscribed as djoh797014@yahoo.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|