Had a similar problem with a Ford truck. Turns out that the sintered
metal filter was clogging from fine silt like contamination. Turns out
some kids had put leaves in the fuel tank. All the symptons were the
same.
Moonstone
-----Original Message-----
From: Ron Fraser <rfraser@bluefrog.com>
To: 'Cullen McCann' <cmccann@lwpb.com>; tigers@autox.team.net
Sent: Fri, Sep 18, 2009 1:14 pm
Subject: Re: [Tigers] (Non-Tiger) Fuel pressure falls off with temp?
Cullen
I'm not real familiar with the fuel system on the Ford Truck but it
is possible there is a filter sock on the tank pickup tube, it might be
split or collapsing. Another possibility is that there is something
in
the tank that is clogging the pickup tube. So Check the tank for
contamination of any kind.
I had an 83 Escort that would stall too often. I finally dropped
the fuel tank and found a large jelly like blob that would cover the
pickup
tube filter sock and stall the engine. I had to use about a Qt of
Lacquer
thinner to dissolve the blob.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net
[mailto:tigers-bounces@autox.team.net]
On Behalf Of Cullen McCann
Sent: Friday, September 18, 2009 10:32 AM
To: tigers@autox.team.net
Subject: [Tigers] (Non-Tiger) Fuel pressure falls off with temp?
All,
I try not to bomb the list with Non Tiger stuff, but we are a bit
desperate,
and you all can be so helpful.... I guess it could apply to a
Tiger...the
dynamics of the system aren't any different that I can think of. ...and
we
really need some good advice...
Here is the situation, my good friend and I have built an early 70's
full
size ford truck 4x4...The fuel pressure falls off slowly from 6.5 psi
on the
gauge to about 3 or so....and eventually even lower until it tries to
die as
the engine warms up...over the course of a few miles driving or several
minutes of engine at full operating temp.
Here is what we have tried:
1. considered a bad fuel pump, replaced it with new and it didn't
change 2.
considered a bad regulator, replaced it with a brand new one from
summit,
didn't change 3. considered a bad gauge, replaced it with no change 4
considered a problem with venting in the tank or not enough
vent...checked
the cap and vent line and its fine, no change 5. considered vapor
lock....if
this is true, what causes it and how do you fix it? the fuel line is
routed
in nearly the exact same format as the factory...cant imagine what would
cause it.... 6. re-routed the fuel system with soft line to by pass
regulator and remove line from near engine...no chance in the problem
Any ideas would be appreciated....we are getting desperate....here is
how
its setup in case it matters:
Engine and such:
Ford 351 Windsor - roller conversion
9.3:1 compression, forged pistons
Edelbrock aluminum heads
comp cam (521/536 lift, 230-ish duration)
Edelbrock 650cfm Thunder AVS carb
Edelbrock Performer RPM intake
Shorty headers with 2-1/2 mandrel bent exhaust
Fuel system specifics:
Stock tank
Stock 3/8-inch lines from tank to pump
Summit Mechanical 'high volume' fuel pump - 110gph, 8 psi
-6 AN braided hose from pump to regulator
Adjustable regulator - set at 6.5psi
-6 AN braided hose from regulator to filter
In-line fuel filter right at carburetor
Full tank of 91 octane fuel
Thanks Friends!
Cullen
You are subscribed as rfraser@bluefrog.com
Tigers@autox.team.net http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.409 / Virus Database: 270.13.105/2380 - Release Date:
09/18/09
07:49:00
You are subscribed as drmoonstone@aol.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|