When I first started autocrossing my car, I ran the 7/8" solid front bar
with an aftermarket Addco rear bar of undetermined diameter. The location
hardware on the bar was sketchy and not well located, but even so the increase
in rear roll stiffness was significant. Even with the rear Konis at full
soft, the car had too much oversteer and the experiment with the rear bar
ended quickly. Ultimately, I fell into the camp of wanting as much
compliance as possible in the rear suspension, basically just trailing along
behind
the front, and doing my suspension tuning with just the front end, with
rear shock adjustment at the margin.
Mike
In a message dated 9/15/2009 12:32:58 A.M. Pacific Daylight Time,
maliburevue@yahoo.com writes:
Does anyone out there run a rear sway bar? Details? Likes/dislikes? If so,
what size front sway bar do you run with it?
You are subscribed as mwood24020@aol.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|