Since I have boxed in the motor by putting in some fender wells, the
motor house gets downright hot! I was thinking, usually dangerous to
self and by standers alike, that I could make a couple of 1/2 inch thick
spacers to go between the hood and the hinges. That would open the front
of the hood a 1/2 inch and let ram air in to the motor house. ANd take
some of that heat down and out. Anythoughts to this hair brained idea?
The rear of the hood is held in place by three dzus buttons but the
front is held in place soley by the hinges.
Thoughts? COmments? Jeers? Barbs? I'll take them all if related to the
issue...
mayf
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|