I just recently bought a turn signal switch with flasher on epay. Was
advertized as Lucas NOS for Alpine and Tiger. Lucas P/N is 34721. After
Bill's post I decided I had better measure the switch. Dimension across the
yoke is about 1.62 inches. Looks about right. Better check it on the car
before I get too serious about my flasher project. Horn on my 1A works OK
so I'm planning to use the switch as a flasher - and then some. Plan is to
make it flash if the lights are off and to make it toggle between hi beam
and lo beam if lights are on. To that end I have already bought some of the
very finest 12V relays (about $10.00 for a set of five on epay - made in
China). I'll only need two relays for the job; the rest will be solid-state
magic. Shouldn't need the floor switch any more after the conversion but
will probably leave it where it is so things look correct.
- Will B3820011570
____________________________
Will Seay wseay@embarqmail.com
----- Original Message -----
From: " Ron Fraser" <rfraser@bluefrog.com>
To: "'Stu Brennan'" <stubrennan@comcast.net>; <tigers@autox.team.net>
Sent: Thursday, August 06, 2009 9:07 PM
Subject: Re: [Tigers] Headlamp Flasher
My Alpine Parts list shows the Rootes part #1223742 for the headlamp
flasher and there is a 2nd number at the end; 34719A. I believe 34719A is
a Lucas number.
Ron Fraser
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|