Looks like standard Ford hardware to me, from about '77 to '85 where
they used the Duraspark module.
I gutted one of these distributors and used the upper halfshaft, with
the reluctor, and the advance plate, inside an early style distributor
with a vacuum advance diaphragm mount. I wired it direct to my MSD6AL
and it worked great until the cam ate the distributor gear (no, it was
not a roller cam engine - just poor lubrication).
Theo
> -----Original Message-----
> From: tigers-bounces@autox.team.net
> [mailto:tigers-bounces@autox.team.net] On Behalf Of Owain Lloyd
> Sent: June 30, 2009 3:59 PM
> To: tigers@autox.team.net
> Subject: [Tigers] distributor
>
> i wonder if anyone knows what the internals of this distributor are?
>
> it has a regular ford stamped lower body and this non
> standard rotor shaft.
> there is a blue plastic 'large' style upper body and a red
> HEI cap. none of the parts are marked. i'd like to get a
> new rotor for it but i'm not sure what to buy to fit that shaft.
>
> http://owainlloyd.no-ip.com:8080/photos/Tiger/dizzy/IMG_0858.jpg
> http://owainlloyd.no-ip.com:8080/photos/Tiger/dizzy/IMG_0859.jpg
>
> thanks,
>
> - owain.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Tigers@autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|
