For archive purposes, I am sending this to the list.
First of all, thanks to all of you who responded on the list and me
personally. I have it working properly now and the cruise will hold at 90+
mph...and below of course.
Just a quick summery of what I did. The magnet is installed on the drive
shaft, blue wire to the (-) side of the coil, and the rest as the
instructions say.
I may have had an intermittent signal to the coil but fixed that and tested
it per the instructions.
DIP SWITCH setting 1 to 7 that are working on my car.
1 = on
2 = off
3 = off
4 = off
5 = off
6 = off
7 = on
I must say that I am very impressed with this ~$80 unit. It holds the speed
better than my 2008 GMC.
Thanks again and see you at SUNI V.
Duke
B382002037
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|