Jim
I took some measurements that might help you.
1st find the center of the trunk lid at lower edge - my trunk is 982mm wide,
center = 491mm.
Use masking tape and pencil to mark centerline also place some tape at the
lower edge where the badge is located.
I used a square from the lid edge up to the badge hole centerline.
Center of lid to badge hole measurement then lip edge up to BOTTOM of each
hole.
352mm x 92.7mm You should be able to see this hole from the back side of
the trunk.
379mm x 62.4mm
393mm x 92.7mm
The hole diameter is 4.1mm.
Lay it out see if that will work for you.
Hopefully it will get you close.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of James E. Pickard
Sent: Wednesday, April 08, 2009 12:16 AM
To: tigers@autox.team.net
Subject: [Tigers] Need a favor
I need a favor from someone willing to remove the badge from the lower right
corner of the trunk lid for a few minutes. I propose:
1) remove the badge
2) wrap the lower right-hand corner of the trunk lid with heavy-duty foil
3) locate the holes in the foil
4) replace the badge
5) mail me the template
Anybody out there willing?
Jim Pickard
B9473298 ('65 Tiger)
AN5L/12109 ('59 Sprite) - sold
2003 Mini Cooper
Lafayette, LA
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.238 / Virus Database: 270.11.46/2046 - Release Date: 04/07/09
17:53:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|