Lee,
Believe it, or not, I have a Bosh sensor on my Edelbrock kit. It is in
the right bank exhaust pipe just below the manifold. The instrument
package came with a threaded bung to weld to the manifold sealing the
hole you make. Weld first, drill out later - make sure no interference
in engine compartment.
It is connected to an LED array, and senses Air/Fuel ratio for checking
engine tuning. See the difference between idle, part, and full throttle!
Here is an Amazon.com link of my device:
http://www.amazon.com/Edelbrock-6593-Fuel-Ratio-Gauge/dp/B00062YBES
Steve
___
Steve Laifman
Editor - TigersUnited.com
<http://www.TigersUnited.com>
http://autospeed.com/cms/A_3032/article.html
AAAGLASSS@aol.com wrote:
> _http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=370124041483_
> (http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=370124041483)
> Where does this go???
>
> B382002560
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|