on a related note, does anyone know of a flaring tool that will flare
3/16 stainless pipe?
i've had to temporarily run copper along the rear axle until i can
figure this one out. the normal hand-held flaring kits just slide off
stainless tubing.
On Fri, Nov 21, 2008 at 6:36 PM, <MACHWIL@aol.com> wrote:
> Hello,
>
> I've used Classic Tubes brake and fuel lines on my 1a. They worked fine,
> absolutely no problems at all. Don't recall the prices but you couldn't make
> them from scratch, IMHO.
>
> Bud Williams
> 0490
> **************One site has it all. Your email accounts, your social networks,
> and the things you love. Try the new AOL.com
>
>today!(http://pr.atwola.com/promoclk/100000075x1212962939x1200825291/aol?redir=http://www.aol.com/?optin=new-dp
> %26icid=aolcom40vanity%26ncid=emlcntaolcom00000001)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Tigers@autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|