There was an aold CAT tewch tip that suggested you could drill a small
hole in the bell housing in order to grease a greasable throwout bearing.
Prehaps to PO did that. I'd just plug the hole to keep the dirrt out.
Dave
In a message dated 9/11/2008 9:32:13 P.M. Central Daylight Time,
Mgman71@comcast.net writes:
----- Original Message -----
From: George Re
To: tigers
Sent: Thursday, September 11, 2008 7:32 PM
Subject: Bell housing
Thank you to everyone on the info I got on the harmonic balancer. I have
another question? I just removed my engine tonight and found the PO for
some
reason cut a hole in the bell housing I do not think there
would be any problem with if I just left it alone because I have used it for
a few years and no problem. But I would like to replace it are there any
early Fords with the same bell housing or is this one just made for the
tiger?
Thanks in advance.
George
B9471055
You are subscribed as djoh797014@aol.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
**************Psssst...Have you heard the news? There's a new fashion blog,
plus the latest fall trends and hair styles at StyleList.com.
(http://www.stylelist.com/trends?ncid=aolsty00050000000014)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|