Hey guys: (any "gal" listers out there?)
Does anyone know if its possible to press the shaft back in a Miloden water
pump to gain clearance from the rad?
Since I installed an alloy rad approx 3/4 inch thicker than stock, and
fitted the original shroud, the fan blades are now buried
in the shroud completely. I understand for maximum effect the blades should
be roughly 2/3 inside - 1/3 outside the shroud.
Two possible solutions: fit a shorter water pump (does one exist?) or
shorten the shroud, which would reduce the shroud's
effectiveness.
I'm not sure which is the better of two bad choices: leave the fan buried ot
cut down the depth of the shroud?
Any suggestions?
Cheers,
Dave Munroe
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|