Or some snap ring pliers will work as well.
----- Original Message -----
From: "Harry B. Elam" <harryb@elams.org>
To: <tigers@autox.team.net>; <CoolVT@aol.com>
Sent: Sunday, July 20, 2008 7:42 PM
Subject: [Tigers] Tiger shift knob
> Use small needle nose pliers separated the width of the holes in the
> bottom nut. you can hold the bottom nut this way while tightening the
> top part to the correct attitude to show the shift pattern.
>
> Harry Elam
> B382000471
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as gammaman@mokancomm.net
>
> Tigers@autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive
>
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.138 / Virus Database: 270.5.3/1563 - Release Date: 7/20/2008
> 12:59 PM
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|