John's right. Mark the hinge position on the boot lid. Then have some hold
the lid open while you remove the 4 bolt. Rotate the boot support and the
tension is relieved from the spring. Piece of cake from there. Remember the
hole that the spring is using at the back.
A broom handle or 1x4 easily hold the lid up so you can continue with the
tank removal.
Please advise the list os to what product or method youb are going to use
to coat the tanks. Inquiring minds want to know.
Dave
In a message dated 7/12/2008 8:46:31 P.M. Central Daylight Time,
mai65tai@sonic.net writes:
After I sent out the mail---I went out and looked at the truck again and
figured out an easy way.
If you keep the trunk hinge attached to the car end and remove it from trunk
lid side---you can easily rotate the hinge (farther than it eill go when both
ends are attached). This puts the spring on more slack and you can easily
pull
the spring off the hook.
John
You are subscribed as djoh797014@aol.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
**************Get the scoop on last night's hottest shows and the live music
scene in your area - Check out TourTracker.com!
(http://www.tourtracker.com?NCID=aolmus00050000000112)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|