Mayf- I think those slots are there to be able to adjust the bumper as close to
level as possible--one might be closer to the top of the slot than the oppisite
side. Seems some engines set at different points( fore and aft) from the
factory and perhaps the frame rails where'nt always square to each other or on
the saem elevation. The gentelman who just mentioned selling his one owner
orginal might have the best response to your question, meanwhile I will look at
a Mk1 and a S3 and S4 and S5 to see what they show but who knows about the
damage covered up by PO's. The S4 I believe to be untouched but can you really
compare the two. Good luck.
TonytheTiger
--- On Thu, 7/3/08, drmayf <drmayf@mayfco.com> wrote:
> From: drmayf <drmayf@mayfco.com>
> Subject: [Tigers] A quick Front BUmper Question
> To: "tigers@autox.team.net" <tigers@autox.team.net>
> Date: Thursday, July 3, 2008, 4:50 PM
> Slowly getting my Tiger back together after the very
> protracted paint
> operation. In fact, I still do not have the hard top back.
> All went into
> the shop in January,lol... But I do have the car back and I
> am putting
> bits and pieces back on. I have the rear bumper on and now
> an ready to
> put the front one on. But, I see that the brackets are
> sensitive to
> location. Do the slotted holes go down or up? Slots closer
> to the
> ground or farther away..
>
> mayf. way off and very far out in a molten lead kinda
> ambient
> temperature today...
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as achd73@yahoo.com
>
> Tigers@autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|