I bit the bullet and started taking apart my rear axle. I got the first hub
off real easy, because the key was worn and the hub was loose. The axle keyway
is a little oversized now so I'm thinking of having a new key made that is a
little bigger on one half, to fit tight again. Any way, the axle is not
budging and I've worked on some rear ends that have a C-clip on the inner end
to keep it in place. I know the book doesn't say there's one there, but I just
want to verify before I really start hitting the slide hammer. I'm also going
to the machine shop tomorrow to have a plate made to duplicate the function of
the special tool. I modified one of my slide hammer attachments but it doesn't
fit as well as it should. Any advice is appreciated.
Steve
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|