Both the temperature sending unit and the starter solenoid are shown as
being grounded. The question is how well do they have to be grounded:-) Will
using teflon tape on the threads of the sending unit allow the thread to cut
through and still ground the unit?
I wasn't especially careful in scratching away paint at the base of the
solenoid to ensure good contact nor was I careful in being sure that the
washer
on the bolt was making good contact with bare metal to attach the solenoid.
How well does this thing have to be grounded?
I guess I am used to a picky electrical inspector that insisted that the
paint be scraped down to the bare metal and the metal threaded to ensure a
good
ground.
Mark
**************Vote for your city's best dining and nightlife. City's Best
2008. (http://citysbest.aol.com?ncid=aolacg00050000000102)
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|