Could be the throwout bearing.
Once your in there you might as well do the clutch.
Centerforce gold is what you want I think. I have one and like it very much.
Smooth, not to heavy.
I think it's the same part that goes in a 4 speed 65 Mustang. Could be wrong
though.
Have fun... ;)
Scott Hutchinson
Director of Operations
Netjets Large Aircraft
Office 860.292.1191
Mobile 843.290.2805
----- Original Message -----
From: tigers-bounces+shutchin=netjets.com@autox.team.net
<tigers-bounces+shutchin=netjets.com@autox.team.net>
To: tigers@autox.team.net <tigers@autox.team.net>
Sent: Mon May 12 08:25:00 2008
Subject: [Tigers] interesting clutch observation
as I've mentioned previously, I've been suffering some bad vibrations
from my clutch, its been making unhealthy sounds and smells and my
dyno pulls only got up to 4700rpm due to these vibrations.
well on sunday, i did 5 runs up a Prescott Speed Hillclimb thinking
that if the clutch was going to go soon, it might as well go in
spectacular style. The clutch survived and I had some good runs (will
post videos on youtube at some point), but the point of this diatribe
(and i'm getting to it...) is that on the 130 mile drive back home, I
noticed that sometimes the vibrations disappeared completely until
next time I dropped the clutch. I figured out that if the vibrations
were present, all I had to do was drop the clutch and reengage it 3 or
4 times so get a clean engagement with no vibrations again until next
time it was reengaged when the chance were the vibrations would
return. this strategy worked perfectly for the long stretches of
highway when it was left in 4th gear.
Am I right in assuming that this rules out flywheel imbalance or
anything else and points solely at the clutch? If so is there
anything else that can be deduced? I'm assuming the only solution is
to pull the engine and fit a new clutch?
in which case, are all small block clutches interchangeable? can I
buy the clutch in advance before removing the old one? I believe good
things have been said recently of Centerforce. Any particular model
that is not ridiculously stiff but can handle around 350HP at the
wheels?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
You are subscribed as shutchin@netjets.com
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
* ********
This message contains information which may be confidential and privileged.
Unless you are the addressee (or authorized to receive for the addressee), you
may not use, copy or disclose to anyone the message or any information
contained in the message. If you have received the message in error, please
advise the sender by reply e-mail and delete the message.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|