I used mounts from Sunbeam Specialties with no problems... I have no idea
where Rick gets them from, though.
Something I highly recommend is putting 'safety' bolts in the mounts before
you install them. I did this using pictures from Tim Ronak's 'Lunati 350'
article on the TU site... I used 3/8" flat socket head bolts and left the
nylocks a tad loose for movement. Only special tool needed is a large
countersink bit... simple fix for a whole lot of peace of mind...
http://www.tigersunited.com/techtips/RonakCam/pt-RonakCam5.asp
Jim
382000446
-----Original Message-----
From: tigers-bounces+jim=island.net@autox.team.net
[mailto:tigers-bounces+jim=island.net@autox.team.net] On Behalf Of
CoolVT@aol.com
Sent: May 3, 2008 7:44 AM
To: tigers@autox.team.net
Subject: [Tigers] engine mounts
So listers, are TRW mounts available? Where? Where is another good source
of mounts that fit and are of decent quality? I tried some from NAPA and
another national chain.......metal about 1/3" thinner than original, holes
off
by at least 3/4" and the rubber on one mount about 1/2" thinner than the
other. Both tried were import Asian products. Wow, I can see trying to
cheapen
them, but is anyone actually bolting these on to a Tiger or Mustang????
Mark
**************Wondering what's for Dinner Tonight? Get new twists on family
favorites at AOL Food.
(http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
You are subscribed as jim@island.net
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|