You, the world's fastesst SUnbeam (wannabe) has used many aan aluminum
ball under the hood to measure clearances. Works really well, and sdoes
not leave modeling clay everywhere, lol... And it holds the shape
really well so you can measure it easily.
mayf
Owain Lloyd wrote:
>depends on your hood and engine position. it's very easy to measure
>by putting a loose ball of aluminum foil on top of the air filter and
>closing the hood. i used that tequinique to see if i could fit a
>nitrous plate under the carb. luckily i could :)
>
>On Thu, Apr 17, 2008 at 4:49 PM, Alan Zeni <tiger@missiongranite.com> wrote:
>
>
>>Does anyone know how thick a spacer I can use between a performer intake and a
>> 600 cfm Holly carb? And, I assume that I don't need a "heated" spacer like
>> O.E., right?
>>
>> Thanks..........
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> You are subscribed as owain.lloyd@gmail.com
>>
>> Tigers@autox.team.net
>> http://autox.team.net/mailman/listinfo/tigers
>>
>> http://www.team.net/archive
>>
>>
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>You are subscribed as drmayf@mayfco.com
>
>Tigers@autox.team.net
>http://autox.team.net/mailman/listinfo/tigers
>
>http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|