Tim -
I just did that to an Edelbrock victor pump but don't have the dimensions
handy. The type of balancer does make a difference, if stock, I'm not sure
what it is, but I do have a a flat face aftermarket pulley with some of Dale's
pulleys. And I had to push it back (the flange on the pump) just about to the
back of the pump housing. I had to back it off as it seems the back of the
flange had a taper and it gets into the bearing and causes interference. I
pulled it back just until the rubbing was gone. Looks pretty close. If you do
go too far it is not that hard to pull it back forward, I just put in 2 of the
bolts in the pump face and slowly used it to force the flange forward by the
bolts pushing through to the pump face. Left a small mark but otherwise fine.
Just watch the back of the pump to make sure youi not pulling the shaft out of
the impeller. I was also working on a spacer for use with a stockish set of
march pulleys that likely would work fine
without moving the flange back, but fan likely would still be an issue.
After all that sorry I can't help with the stock measure.
Sandy
----- Original Message ----
From: "Ronak, TP (Timothy)" <Timothy.Ronak@crna.akzonobel.com>
To: tigers@autox.team.net
Sent: Tuesday, March 18, 2008 8:26:17 PM
Subject: [Tigers] Water pump flange height
Listers,
Can anyone confirm the stock pulley flange distance for a 260 Tiger.
Based on my research it should be 4.875 inches from the back of the pump
bolt on flange to the outer face of the pulley flange. I realize this is
different than the shop manual. I am going to go press two pumps but do
not have a pump to go off of that is off of the car. (never thought to
save one) if anyone can confirm this before I go jack up two Edelbrock
pumps I would be VERY grateful.
Best Regards,
Tim Ronak
Services Consultant
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Bus: 949-305-5393
Fax: 425-955-6268
Cell: 949-289-3357
email: timothy.ronak@crna.akzonobel.com
Personal email: timronak@cox.net
You are subscribed as sganz@pacbell.net
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|