As a follow-up to my last email, I ran across this part on eBay:
http://cgi.ebay.com/ebaymotors/FORD-302-V8-OIL-FILTER-ADAPTER-NEW-Mustan
g-5-0-NR_W0QQcmdZViewItemQQcategoryZ33661QQihZ007QQitemZ170147639308QQrd
Z1QQsspagenameZWDVW
It looks like exactly what is needed assuming the threads are correct.
JVP
-----Original Message-----
From: tigers-bounces+parlanti=comcast.net@autox.team.net
[mailto:tigers-bounces+parlanti=comcast.net@autox.team.net] On Behalf Of
Joe Parlanti
Sent: Saturday, September 15, 2007 8:09 PM
To: tigers@autox.team.net
Subject: [Tigers] Oil Filter Adapter
Guys,
I'm in the process of installing a different remote oil filter setup on
my car. Based on some great info from Larry Paulick, I purchased a
Transdapt block adapter, and oil filter mount from Summit Racing. As I
removed the original block adapter, I realized that the block was not
threaded for the standard 3/4-16 nipple as I had thought. The big hollow
bolt that goes through the original adapter is something around 1" in
diameter. So here's my question: Does anyone know where to find and
adapter that would screw into the block with a 1" thread (or whatever it
is), stepped down to a 3/4-16 pipe thread that would mate with the
adapter? I could always reuse the old adapter and simply run the new
hoses from it up to the new bracket, but I'm concerned about the hoses
in the center being too close to the header.
Thanks in advance,
Joe Parlanti
B382000026
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
_______________________________________________
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
|