Joe
The retaining clip is a wire form clip; See Shop Manual Section D,
Page 7.
http://www.tigersunited.com/resources/wsm/wsmD7.asp
I highly recommend to all; safety wire the push rod to the lever arm so you
can never loose the push rod.
Ron Fraser
-----Original Message-----
From: owner-tigers@autox.team.net [mailto:owner-tigers@autox.team.net] On
Behalf Of Joe Parlanti
Sent: Tuesday, July 25, 2006 2:14 PM
To: 'Tiger Email List'
Subject: Looking for a part
Folks,
I'm looking for the pushrod retaining clip that holds the slave cylinder
pushrod against the release lever. If anyone has one, I'd be most
appreciative. Barring that, could someone take a couple photos of one so I
could fabricate something that would work?
Thanks,
Joe Parlanti
B382000026 (Trying to get it finished for TE/AE United in October)
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.394 / Virus Database: 268.10.4/396 - Release Date: 7/24/2006
|