Steve Laifman wrote:
> Not too sure about brand, but I am told that the extruded aluminum
> roller rockers are too high, and might need a clearance hole cut into
> the LAT TIGER valve cover splash plate. If you do not HAVE a steel
> splash plate, it might be a re-po.
>
> Forged rockers can have smaller dimensions that will fit. I have
> Crane forged steel rockers, but only the valve tip contact is a roller.
>
> There is always the use of two valve cover gaskets to consider, but
> then you have to asses firewall clearance.
>
> There must be a bunch of Tiger owners who have actually tried this.
>
> Steve
>
> ___
> Steve Laifman
> Editor - TigersUnited.com
>
>
>
> Amberly Chamberlain wrote:
>
>> Do the Crane 1.7 Roller rockers work with the Aluminum LAT Tiger
>> Valve Covers? I would like to verify clearance before buying a set.
>>
>> Thanks
>>
>> Frank
|