To: | "Amberly Chamberlain" <amberlychamberlain@sbcglobal.net> |
---|---|
Subject: | Re: TIGER VALVE COVERS |
From: | "Theo Smit" <theo.smit@dynastream.com> |
Date: | Thu, 8 Sep 2005 20:22:19 -0600 |
Hi Frank, I measured the 289 heads on my 5 bolt 289, the heads on my '88 5.0 that's going into the Tiger, and some E7TE heads I'm using to hold down the garage floor. They all measure 4 inches from the block mating surface to the top of the valve cover flange, on the exhaust side. If your heads are taller than that they are not E7TE's. Are they aluminum? Best regards, Theo |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Black Holes etc., David or Gary |
---|---|
Next by Date: | Black Holes, Dan Cordray |
Previous by Thread: | RE: TIGER VALVE COVERS, Theo Smit |
Next by Thread: | RE: TIGER VALVE COVERS, MSN |
Indexes: | [Date] [Thread] [Top] [All Lists] |