tigers
[Top] [All Lists]

RE: Carb gas leak

To: <Caseyh4312@aol.com>, <tigers@Autox.Team.Net>
Subject: RE: Carb gas leak
From: " Ron Fraser" <rfraser@bluefrog.biz>
Date: Wed, 9 Feb 2005 12:03:37 -0500
Joey
        You need to check the float level first.    Take the air cleaner off
and with the engine cold, turn the ignition to ON, do not start the engine.
The fuel pump should click for a couple of second and then stop.  If the
fuel pump continues to run, turn ignition OFF.    The carb will look wet
inside and that means the float is not shutting the fuel off.

        Take the top off the carb and see what the float is doing; if the
float is at the bottom, check to make sure it is free to travel up and down
and that it is attached correctly to the fuel inlet and needle valve.
Remove the float and check to see if it will float in water, if not you need
a new fuel float.  If it is up and the fuel level is high then the float
needs to be adjusted, also check the needle valve to see if it needs
replacement and check the inlet valve for dirt.   The rebuild kit has
direction about float level adjustments, read and follow.   After making
adjustments and with the top still off the carb, turn the ignition to ON and
watch the fuel level and listen for the pump to stop.  Turn the ignition
OFF.   If everything is OK put the top of the carb back on and install the
air cleaner.

        Bushing the throttle shaft needs to be done in a machine shop by
someone with the correct tools and experience.

Ron Fraser
        

-----Original Message-----
From: owner-tigers@Autox.Team.Net [mailto:owner-tigers@Autox.Team.Net] On
Behalf Of Caseyh4312@aol.com
Sent: Tuesday, February 08, 2005 4:31 PM
To: tigers@Autox.Team.Net
Subject: Carb gas leak


ok guys i got another one for  ya,
 
there is just a little tiny bit of  gas leaking from the carb. it is leaking

from the long shaft that holds the  butterfly things on. Well when looking 
strait at the car, it is leaking  from the left hand side. The shaft is like
the 
bottom most thing. 
 
Now is there a gasket or bushing  that i can use from the carb kit that i 
got? What does it look like if there  is.
 
Thanks
 
Joey Hiykel  1966 Tiger MK1A
B382001072 LRXFE JAL#  661104


-- 
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.5 - Release Date: 2/3/2005
 

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.300 / Virus Database: 265.8.5 - Release Date: 2/3/2005





<Prev in Thread] Current Thread [Next in Thread>