The aerodyne hood fit fantastic. Only trimming at the cowl edge as per
fitment allowance.
Best Regards,
Tim Ronak
Business Development Manager
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Off: (949) 305-5393
Fx: (425) 955-6268
Cell: (949) 289-3357
email: timothy.ronak@akzonobel.com
VM: (800) 234-6747 ext. 2257#
This message, including attachments, is confidential and may be privileged.
If you are not an intended recipient, please notify the sender then delete
and destroy the original message and all copies. You should not copy,
forward and/or disclose this message, in whole or in part, without
permission of the sender.
-----Original Message-----
From: CoolVT@aol.com [mailto:CoolVT@aol.com]
Sent: Tuesday, January 11, 2005 10:29 AM
To: RMEbstein@aol.com; Timothy.Ronak@AkzoNobel.com; tigers@Autox.Team.Net
Subject: Re: Aluminum vs. Carbon Fiber vs. Fiberglass
Rodney,
You should definitely speak with people who purchased and installed these
replacement hoods. In letters a few years back some members mentioned that
there was normally a problem with "fit-up" of the new hoods and that a body
shop could spend hours and hours fitting and trimming...and then of course
comes the finishing. It sounds like these additions could exceed the cost of
the part itself. If you need the services of a body shop I doubt that you
will find one that will work for less than $75.00 per hour.
Mark L.
|