Steve,
The spacers were fabricated based on info supplied by Cullen Bennett.
Cullen did a very nice cad drawing of the motor mount heat shields and
washers, this was back in August of '95 when I'd only been working on the
restoration for a little over 2 years (-;
I'll send you the drawing to your personal address since we can not post
image files to the list.
.875" OD
.45" ID
.125" thick
Frank
B9471116
> From: Steve Laifman [mailto:SLaifman@SoCal.rr.com]
> Sent: Tuesday, December 28, 2004 1:10 PM
> Subject: Re: Useless paranoia when I should just wait and see...
>
>
> 3) Measure motor mount riser washer OD, ID and thickness, please.
|