The original dip stick & tube measurements are:
Stick - 24 7/16" from the tip to the inside top of the "bell" cover/dust
guard.
Oil "add" mark 1 1/8" from tip, oil "full" mark 2" from tip.
--
Tube - 15 15/16" overall. 14 3/4" from the top of the "stop/seating
ring" (were it goes into the timing gear cover) to the top of the tube.
7 5/16" from the top of the tube to the center of the "mounting wing".
--
With the stick installed in the tube, the tip of the stick protrudes 9
1/2" out of the end of the tube. (measured from the tip of the stick to
the bottom of the tube "stop/seating ring")
David Franchi
|