Derale Fan update and Murphy's law

[Chris Mottram <c_mottram@yahoo.com>]

I installed my new Derale fan #17015 by shimming the
engine up about 1/16 inch and using 1/2 inch spacers
(basically short steel tubes on each bolt) from ACE
hardware between the fan and the pully.  Everything
lined up great.  I decided to flush the system.  The
fan was  cooling so well that I had a hard time
getting the engine up to operating temp in my garage. 
A little cardboard in front of the radiator fixed
that.  10 minutes into the flushing cycle and my water
pump became Niagra falls.  Go figure......
Now it all comes off again.

Chris


                
__________________________________