Piece o' cake, Mate:
Moss Motors, parts number 263-230 ($1.50--clamp, large) and 262-200
($0.65--clamp, small) in their Sprite and Midget catalog. 1-800-667-7872.
I'm also told Subaru clamps will fit--if you've GOT to fulfill the
'three days, drive 100 miles' quota, you can drive to the T.O. Subaru
dealer, hassle with the parts clerk and, in the event that they really
do have clamps that will fit (in stock, no less), balance your time and
the money spent against the shipping cost of just ordering the clamps
from Moss direct :-) Mind you, 'the quest' is infinitely more
satisfying, but....
Regards
David Sosna
Tom Witt wrote:
> I guess I should have known better, but a month or so back I asked about the
> plastic tie wraps that came with the SS rack covers. I recieved a number of
> replies stating that they worked fine. I still had my doubts, but went a head
> and used them anyway. The rack was immaculately clean and the covers were
> proper seated. I pulled the tie as tight as I could with the catch facing the
> top.
> It has been sitting about a month now (attached to the crossmember).
> Yesterday I held the crossmember into place to check my lower fan shroud
> clearance and notice that.... yes, of course, a cover was leaking (at the
> large end). Once you get above "fuel line" sized hose clamps they get too wide
> to fit. Does anyone have a line on where I might possibly find "thin" hose
> clamps large enough to fit the rack (large end - 2"???). Sadly I feel I'm
> headed for my 1001st "search for three days, drive 100 miles ordeals."
> Thanks, Tom Witt
|