Steve, I have two different length hold down screws. On is missing the
top of the screw and the little hat. I used to have a third hold down
screw that was quite a bit longer in the shank than either of the other
two I now have. I would like to know which is correct for my car (the
correct length). I guess I'd also like to know the origin of the other
two if not Alpine.
Frank
B9471116
> -----Original Message-----
> From: Steve Laifman [mailto:SLaifman@SoCal.rr.com]
> Sent: Saturday, November 16, 2002 5:40 PM
> To: Frank Marrone
> Cc: Tiger List (Tiger List)
> Subject: Re: Spare tire hold down length
>
>
> Frank,
>
> The Alpine did not have a hold down screw, nor did it rest on
> the floor.
> I stood vertically against the forward trunk wall, in the small well
> provided in the bottom, and was held with straps.
>
> The Tiger fitted the wheel front side down, and a short bolt screwed
> into a Tiger-only fitting on the floor thru a wheel hold-down
> central plate.
>
> Steve
>
> Frank Marrone wrote:
>
> >I know the Tiger spare tire hold down is supposed to be
> longer than the
> >Alpine hold down. What is the length of the screw for the
> Tiger hold
> >down? What is the length of the Alpine hold down? I think
> I may have
> >seen three different sizes for this screw, were there three sizes or
> >just two?
> >
> >Frank
> >B9471116
> >
> >
> >
>
> --
>
> Steve Laifman
> Editor
> http://www.TigersUnited.com
|