I had a few folks ask me to get back with them if I found anything on the
rotors, therefore I'll post the answer. Below is a definitive response from
Dan. My new favorite parts store, owned by two brothers who are not on
computer and still have all sorts of catalogs for parts going back to the
60s looked up the rotors and told me the very technical answer, "book says
throw out at .310". I have not researched the drums yet... actually, I
still haven't got them to let go of the hubs, but I'm in no rush.
Matt
-----Original Message-----
From: Dan & Lori Fitzgerald [mailto:danlorifitz@earthlink.net]
Sent: Monday, September 09, 2002 8:57 PM
To: Matthew Bouchelle
Subject: Re: Brake rotor min. thickness
Matt,
The new rotors are .500 inch and the minimum is .375 inch. The data came
from a factory service bulletin. Hope this helps.
Dan
|