Bob Rice wrote:
> Does anyone have a recommendation on where I can get metal brake line and
> fittings for my Sunbeam. I'd prefer to make the lines myself, as opposed to
> buying pre-made lengths.
>
> Bob
Bob,
This was covered a while ago. Sunbeam Specialties carries various straight
lengths of "bubble flare" tube. Be careful, some lines require a "bubble flare"
on one end and a "double flare" on the other. Can't remember which ones, but
the rear brake cylinder comes to mind.
Others report bubble flare tubing available at local parts stores.
There are a number of tools that claim to do this job. Some use the normal
double-flare tube but stop after the "bulge" process. The angles are not the
same, but some claim they conform on tightening. Unconfirmed.
Snap-on is reported to make the very best flare tool for any type of flare,
including fittings for bubble flare. As usual, Snap-on reserves the right to
sell premium tools and premium prices. Could buy a lot of SS pre-mades, and do
the whole club. (9-)
Steve
--
Steve Laifman
Editor
http://www.TigersUnited.com
|