Frank,
When you do the conversion be very careful around the locating hole for the
transmission. I had a housing that was welded and the heat caused the flat
trans mating surface to warp/drop and made the hole oblong. It took $150 to
fix the resulting welded piece after heli-coiling and surfacing and reboring
the large locating hole.
By the way NO WOULD DO THE BORING!!! I got it done as a favor and paid
dearly at that but no where near what the fellow spent in time. In the end
it was great but be aware of welders who fail to contain the heat.
Best Regards,
Tim Ronak
Business Development Manager
Akzo Nobel Coatings
Off: (949) 305-5393
Fx: (949) 305-5394
Cell: (949) 439-4784
email: timothy.ronak@akzonobel.com
VM: (800) 234-6747 ext. 2257#
This message, including attachments, is confidential and may be privileged.
If you are not an intended recipient, please notify the sender then delete
and destroy the original message and all copies. You should not copy,
forward and/or disclose this message, in whole or in part, without
permission of the sender.
|