Folks,
My Tiger 2 now looks necked. Another Tiger 2 owner
decided he wanted my SS fender-well trim and side SS trim
a lot more than me.
Sort of Non- Tiger Related: I am looking to buy
a used metal lathe with a 3 and a 4 jaw chuck that will hold a 6"
(or bigger) billit. Lots of accessories needed too.
Trying to extend a 9" Rear end that is to narrow for the
Tiger. Need to do a bit of machining.
E-Bay has several lathes, but I need one from Florida
as the truck shipping cost goes up real fast. Did find one
that might be too big, only bid was $100 for a lathe that
weighed around 80,000 lbs with 20,000 lbs of accessories.
Right, I figure I could haul it on a trailer behind my Tiger.
&-).
James Barrett Tiger II 351C and others
|