I have seen a set of Zenith wire wheels on a Tiger. They looked nice and
beefy. Problem was they were quite heavy, and after several years outside, the
were starting to rust.
Larry
Steve Laifman wrote:
> Nick,
>
> Shelby only used the AC supplied wire wheels on the first 289 Cobras.
> They were a little light in the strength department for the V-8. As soon
> as he increased the horsepower he went with mags.
>
> I had 16" wire wheels on my XK 120M Jag, and they were 52 mm hubs, not
> the 42 mm most commonly seen. They were just adequate for the 190 hp engine.
>
> Most US engined cars used US Zenith wire wheels, with thicker spokes and
> a gear drive, rather than fine splines. Same wheel used on Mercedes
> retrofits. Might have a look at those.
>
> Cadillac tried Dunlops for about a year. They were slightly beefier than
> the English version, but still fragile.
>
> Rootes never would put the Alpine hubs and wire wheels on the Tiger, as
> they couldn't take the power, and Morgan would not use wire wheels on
> their +8 Rover (Buick) 225 CID engine, even though they still use them
> on the smaller engined versions.
>
> Take care.
>
> Steve
> --
> ____________________________
> Steve Laifman
> Editor
> <http://www.TigersUnited.com>
|