Tom, this is good info, and goes in the file. Let me know how the 3/"
bore works.
Larry
Tom Witt wrote:
>
> Larry, Jim, The Datsun Master Cylinder also comes in the 3/4" size. Some of
> the selected Datsun's had this size. I know that it was used on the early
> 510's and the one I got (3/4") at Pick A Part was from a 710. I'm not sure
> if the 710 came with the 3/4" as the MC that I got looked rather new (which
> is why I got it) and was probably a replacement. I would like to tell you
> the effect of the 3/4" bore, but I'm not on the road yet. The early Mazda
> RX-7 MC looks like it might adapt well too. It is cast steel (iron?) and in
> the 13/16" bore size. Tom Witt
|