Chris,
These are the kind of tranny serial numbers found in late '64 Tigers.
Depending on what they want for these trannys, I'd buy them just for the
parts even if they didn't have the right tail sections. I'm thinking maybe
you could take the best parts from each and make one or two good ones, but
that's probably wishful thinking. If the shifter locations look the same as
your Tiger's, then I'd bet they are the right trannys, give or take 1/8"
measurement error.
I'm sure someone else on the List can not only tell you for sure, but give
you an idea what a good used tranny is worth.
Good luck,
Bob
At 05:47 PM 9/27/99 -1000, Chris Vaught wrote:
>Today i went to the place where i bought my tiger. it is basically a junk
>yard. while i was there i notice two early 4 speed top loaders. i know that
>the output shaft on the tiger is shorter but by how much? these two had 15
>1/2" tail shafts. my tiger appears to be 15 3/8". it was just a quick
>measure at the lot so i could be off 1/8". the numbers are heh e 011839 and
>heh e 011121. Are these tiger tranny's or is there some othere differences
>that i do not know of. one of them had the tiger linkage all but the shift
>lever. if you have any info please get back to me asap.
>thanks
>chris
Robert L. Palmer
UCSD, Dept. of AMES
619-822-1037 (o)
760-599-9927 (h)
rpalmer@ucsd.edu
rpalmer@cts.com
|