On Fri, 17 Sep 1999 13:45:29 -0400
STUART_BRENNAN@HP-Andover-om3.om.hp.com writes:
I had planned to do some polishing on the aluminum wheels I finally
installed on the Tiger. I was going to try a few different compounds
I've had
kicking >around the garage for years.
I don't want a mirror finish on the wheels, I just want to clean them
up a bit, even out the finish, etc. There are both machined and rough
cast
portions visible. It's probably been a couple years since these had been
touched, and when I bought them up, the had been sitting outside, covered
with
leaves, etc. What's good these days for cleaning and polishing aluminum?
Stu,
I am not an expert on this;but, this year I bought some 60 vintage
aluminum wheels for my 63 F100.
I used WD 40 and very fine 000 steel wool. Worked fine
Cliff 9471187
COMORGAN@JUNO.COM
|