Thanks for the advice I got the pistons out with a conbination of 125# air,
WD-40, and a wood hammer. I think I may need some new pistons though. After
smoothing them with 600 grit wet/dry sand paper there appears to be a
little pitting in a couple spots. I have three more sets of calipers to
take apart so hopefully I will find two good sets.
Chris
BTW wich way are the little arrows on the metal plates supposed to point. I
normally would pay close attention to this on disassembly but I had a
friend working my brakes, who quit after four hors of trying to get the
pistons out.
|