I came across a couple pre molded hoses that fit really nice on my "1A"
Tiger:
HEATER CORE TO HEATER VALVE: Dayco 80395. It has a 90 degree turn
molded in at just the right place. Only one end has to be cut.
REAR OF CARB HEATER TO THE "T" NEAR THE FIREWALL: AutoZone 4101.
Again, it has nice 90 degree bend, and is easily cut to fit.
Stu
Daniel S. Eiland wrote:
>
> I was looking through some of my notes from the list but could not find a
> cross reference # for the molded heater hose. Does anyone know if there is
> something off the shelf that can be used to replace the preformed heater
> hose that hugs the firewall and goes to the heater valve?
> Dan
|