Stig Ram wrote:
> I´ve changed (tried to) the waterpump on my Tiger Mk 1.----.After a lot
> of this
> and that I found that the Workshop manual
> said 5,15 inch (130,82 mm) between the engine mating surface and the
> waterpump Hub-pulley. I measured 131 mm on my new pump as well as on
> another Tiger pump. But my old ( not reparable) pump has approx. 125 mm!
> And is perfectly aligned w. the crankshaft and generator pulleys! So now
> to the QUESTION(s):
> What engine does I have?
> :-) Stig Ram
> Ps. My SnowTiger as well as my Alpine SV is presently hibernating,
> awaiting the Spring, Its cold here.
Stig,
I have found data that suggest the venerable Official Workshop Manual is in
error in this measurement. It does indeed list 5.15 inches for the MkI,
MkIA 260, and 5.43 inches for the MkII 289.
My information says the "correct measurements" should have been 4.875
inches for the MkI/IA, and 5.1 inches for the MkII.
Hope this helps.
Steve
--
Steve Laifman < Find out what is most >
B9472289 < important in your life >
< and don't let it get away!>
_/_/_/_/_/_/_/
_/ _/_/_/ _/_/_/ _/
_/ _/ _/ _/ _/ _/ _/_/_/_/
_/ _/ _/ _/ _/ _/ _/
_/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
_/
_/_/_/
|