In a message dated 2/23/99 2:24:43 PM, laifman@flash.net writes:
>FrizBMG@aol.com wrote:
>
>> ........
>> Doug also mentioned that the bearing retainer was a bit different.I
>assume he
>> is talking about the throw out bearing on the fork..
>> Goodluck
>> Tony
>
>No, Tony
>
>The 6 bolt tranny case has a transmission front bearing retainer that is
>larger
>in diameter than the 5 bolt. The hole in the bell housing matches. These
>are
>easy to come by, and a bolt-on replacement.
>
>Steve
>--
>Steve Laifman < One first kiss, >
>B9472289 < one first love, and >
> < one first win, is all >
> < you get in this life. >
>
>
>_/_/_/_/_/_/_/
> _/ _/_/_/ _/_/_/ _/
> _/ _/ _/ _/ _/ _/ _/_/_/_/
> _/ _/ _/ _/ _/ _/ _/
> _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
> _/
> _/_/_/
>
>
OK Steve
so if I use a 5bolt trans (small ears) on a 6 bolt bell that has been drilled
for the smaller (5bolt ) pattern ,then I cant use my front bearing tranny
piece,and I MUST use the larger 6 bolt piece?
Well what about the shift fork? Is that larger/different also or will the 5
bolt piece work in the 6 bolt bell?
Thanks
Tony
|