Bill Rogers wrote:
>Now for the question. What is the best way to clean the terminals on
the
>wiring harness? Has anyone used something like silver dip with a water
>rinse? Any suggestions?
I've had good luck with a spray contact cleaner I picked up at a
local electronics-hobby surplus store; they also sold me a spray
"preservative and conductivity enhancer". A handy, and cheap, tool for
getting to hard to reach areas, like the inside of "female" end bullet
connectors, is a pipe cleaner; they sell 'em in packs at craft stores
and, I suppose, tobbaconists. What _didn't_ work for me was when I cut
off a short length of pipe cleaner and chucked it up in the Dremel tool;
they just didn't hold up under the RPM's.
Lawrence R. Wright
Purchasing Analyst
Andrews Office Products Div. of USOP
lrw@aop.com
Ph. 301.386.7923 Fx. 301.386.5333
|