They make flywheels, clutches, and hydraulic throw out bearings. It is spelled
McLeod. They are distributed through PAW or direct. (PAW is cheaper) PAW # 818
998-6000. I believe the McLeod number is 714 630-3668. I have one in my 427 and
my 100 lb. wife has no problem with the clutch.
Craig Wright
TigerCoupe@aol.com wrote:
> In a message dated 12/21/98 4:58:09 PM Pacific Standard Time,
> mmeswarb@itexas.net writes:
>
> > Basically its a hydraulic
> > throughout bearing...........Maybe Tom can
> > supply the manufacturer or part number for this throughout bearing.
>
> Mark,
> Being 100% hydraulic throughout, this certainly sounds like a very unusual
> bearing! Actually, this thread on the hydraulic throwout bearing ran back in
> September, and Tom Hall wrapped it up with the following post:
>
> >>At 10:57 AM 8/6/98 +0100, you wrote:
> >>Gary
> >>>I'm going to bet you the answer you get is the unit is an hydraulic throw-
> out
> >>>bearing made by _ MACCLEOD!
>
> >>Yes, this is the right one.
>
> >>>They are known to seep fluid inside the bell housing.
>
> >>The way you prevent this is to remove the McL O-Ringed fittings on the
> >>bearing housing and replace them with standard 90 degree fittings. A lot
> >>more work to install the assembly, but I have 0 leaks in three years of
> >>operation.
>
> >>Tom
>
> Dick Barker
--
**********************************************************************
Craig Wright Product Design Group, Inc.
craig@p-d-g.com 4635 Viewridge Ave.
(619) 569-3484 x309 San Diego, CA 92123
fax: (619) 569-3490 http://www.p-d-g.com
**********************************************************************
|