My Exhaust pipes seem to find there way up against the frame from time to
time.
Is there any thing to wrap around them that will not turn to soot or do I
need to figure out a way to bend them?
My header tank has a pin hole in it so small I can't see it wth a magnifying
glass.
Is there a coating for this as there is for gas tanks?
My 260 V-8 lost its oil dip stick and my rebuilder broke the dip stick tube.
So I made new ones - from what? I don't Know.
Can some one with an original dip stick and tube post the relevant lengths
of both?
Length of tube from timing cover to top of tube_______
Length of stick from inside of stop cap to the Full line on stick_______
Just trying to be safe and may have evidence of bubbles in oil.
My new wiring harness seems to have a error in it. The browns wires at the
Battery terminal on the regulator and the solenoid do not go where they are
suppose to. Just a warning it doesn't show up until you try to add an amp
meter and then using the lights mysteriously increases the charging rate! I
can describe in detail if any body cares.
|