Rob Martel, in Ontario (as listed on Mark's web page) does some pretty amazing
work as far as Alpine/Tiger replacement panels are concerned. I have seen a
near-basket case rebuild that he did (Kirt Jenssen's), and it looks really good.
If you are in the north central US or canada, I'd say that's the place to go.
Theo Smit
tsmit@novatel.ca
B382002705
> -----Original Message-----
> From: LARRYR2@ix.netcom.com [SMTP:LARRYR2@ix.netcom.com]
> Sent: Wednesday, October 07, 1998 3:49 PM
> To: tigers@autox.team.net
> Subject: Frame Help
>
> Took my Tiger to the shop the other day to have some rust repaired around the
> spring shackles.
> After they looked at the chassis they found severe rot all through the frame
> and particularly in
> the crossmember.
>
> Does anybody have a source for frame sections, paticularly the crossmember? If
> I can buy these
> already made up the repair will not be too costly. Has anyone else
> experienced this type of
> problem? If so , what resolution did you reach and what was the cost? ANY
> input will be really
> helpful.
>
> Thanks
>
> Larry Rominger
> B9473280
|